PWMPulse frequency duty cycle, adjustable module square wave rectangular wave signal generator
Module highlights:
1.LCDLCD display frequency and duty cycle, very clear, PWMThe output can set the frequency and the duty ratio respectively;
2.The frequency range is wide and the accuracy is high;
3.Cable communication
1. Module description
PWMOutput, you can set the frequency and duty ratio;
The frequency is divided into four range, automatic switching:
1. XXX(No small number): The smallest unit is1Hz,Ranges1Hz~999HzItems
2. X.XX(Timing at 100 points) The smallest unit is0.01Khz,Ranges1.00Khz~9.99KhzItems
3. XX.X(The decimal point is at ten): The smallest unit is0.1Khz;Ranges10.0KHz~99.9KHz
4. X.X.X (The decimal point is at ten and hundreds): The smallest unit is1Khz;Ranges1KHz~150KHz
e.g. Frequency display:100 expressPWMOutput100HzPulse;
1.01 expressPWMOutput1.01KPulse;
54.1 expressPWMOutput54.1KHzPulse;
1.2.4expressPWMOutput124KHzPulse;
The scope of the duty cycle:0~100%Items
All settings parameters are settled and saved.

Parameter settings
Module is4Independent keys are used to set frequency and duty -occupying ratio, support short pressing (increase or reduce one unit) and long -press (rapid increase or decrease). It is very simple. Set the automatic saving after setting the parameter.
3. Module parameters:
1.Operating Voltage:3.3~30VItems
2.Frequency Range:1Hz~150KHzItems
3.Frequency accuracy: accuracy in each range is2%about;
4.Signal load capacity: output current can5~30maabout;
5.Output amplitude:PWMThe amplitude value is equal to the power supply voltage;
6.Environmental temperature:-20~+70℃.
4. Scope of application:
1.Use as a square wave signal generator to generate square wave signals for experimental development and use;
2.The square wave signal used to generate a controller driver;
3.Generate pulses, for supplyMCUuse;
4.Generate adjustable pulses and control related circuits (PWMApplication such as lighting speed and adjustment).

Serial control(Single -chip machineTTLLevel communication)
Communication standard:9600 bpsData position :8
Stop :1
Check Digit :none
Flow control :none
1, set upPWMFrequency of
"F101":Set the frequency to101 HZ (001~999)
"F1.05":Set the frequency to1.05 KHZ (1.00~9.99)
"F10.5":Set the frequency to10.5KHZ (10.0~99.9)
"F1.0.5":Set the frequency to105KHZ (1.0.0~1.5.0)
2, set upPWMDuty cycle
"Dxxx":set upPWMThe occupation ratio isXXXItems(001~100)
For exampleD050,set upPWMThe occupation ratio is50%
3, Read the setting parameter
send"read"String, read the setting parameters.
Set the successful return:DOWNItems
Settings failure returns:FALLEssence

