Power supply, module, LED battery charging, 10A, high power

DC-DC10A high-power downstration constant voltage constant voltage power supply module battery charging LED driver

Module name: 10A Anti -voltage constant pressure constant current

Module nature:Non -isolation antihypertensive module (Buck)

Input voltage:5-40V

Output voltage: 1-36V continuously adjustable,(The default output is adjusted to 5V for shipment,)

Output constant current Default delivery is adjustable outputscope:0.3-10A(Default output constant current measurement to 3A shipment),

Operating temperature:-40~+85 degrees (enhanced heat dissipation when it exceeds 65 degrees)

Working frequency: 380KHz

Conversion efficiency:Up to 97%(efficiency is related to input, output voltage, current, voltage difference))

Short circuit protection:none

Super temperature protection:Yes (automatically turn off the output after ultra -temperature)

Input reverse connection protection: None (can add reverse protection by yourself

Installation method: 42.5mm filament

Wiring:TerminalsIN is input, +/-OUT is output

Module size:Length 67mm Width 58mm Height 28mm

The current detection of the module is low-end detection. Please do not short-connect the input negative electrode and the output negative electrode directly with wires.Intersection

The module is a lower -voltage power supply.The input voltage must be higher than the output voltage.
 

Voltage/Current/Full indicator light/ Adjustment methodThe

Voltage regulation: Follow the voltage you need to rotate the "CV-ADJ" on the power board"Output voltage regulation” potentiometer. Clock mobilization (turn right) voltage is adjusted. Counter-clock (turn left) voltage is adjusted.

Full of indicator light adjustment: One: first"CC-ADJ"Output current adjustment potentiometer: Turn 10 turns in the counterclockwise direction (the requirement of this step is to minimize the output current to prevent the power supply from being damaged due to excessive short-circuit current when the output is short-circuited). 2: Turn the multimeter to the 20A or 10A current gear, and adjust the current to the current that you need when the light is turned on when it is fully charged.3: If the LED2 light is on at this time, adjust the RV3 potentiometer (the potentiometer in the middle) against the clock until the LED2 light is off and the LED1 light is on.At this time, the full indication adjustment has been adjusted.

Output current regulation: In the same way, use the multimeter to hit the 20A or 10A current gear, use the multimeter to short-circuit output, and adjust the "CC-ADJ" current adjustment potentiometer to adjust the short-circuit current to the current you need.

Scope of application:

1. DIY a voltage -stabilized power supply, with a constant flow function, is not afraid to be short -circuited during use, and can protect the load.

2. Power on your short -circuit electronic equipment.

3. Set charging voltage and charging current for various batteries, batteries with different voltages and capacity

4. Use solar cell boards to charge various batteries to charge, with constant current functions, which can prevent batteries from charging and effectively protect the battery.

5. Drive high -power LEDs, can be freely charged and combined,

6. As a power supply power supply, power for your mobile phone or various digital products.