Name: Constant Water Sticker Softener
Number: MS-232 Back glue
Number: MS-231
Capacity: 40ml
You need to shake it well before use, brush the inside, easy to use
This product is water -soluble and will not affect the surface of the part, but it may cause slight softening and corrosion on the stickers.
MS-232 Introduction:The liquid in the bottle can clearly see that there is a layer of white precipitation below. This soft agent not only softens the water sticker, but also supplements the lack of glue of the water sticker itself.
Some models are equipped with thick water stickers and strong hardness, and the sticker itself has very little gelatinity. It is pasted to a curved or uneven model surface.At this time, it is necessary to use the blue cover gel sticker softener MS-232.
Instructions:
First shake this product, shake it, and then shake it as a milky white liquid.On the surface of the lacquer model, some soft agents are brushed with a brush inside the bottle. There are not many soft adhesive agents.EssenceAfter that, move the soaked water stickers to the position you want to paste, that is, the position of the softener is applied, and the position of the sticker is appropriately adjusted with a tadar.The stickers have been pasted, and a clean sticker with a cotton swab has been pasted.Some people will find that the stickers are uneven or wrinkled at this time. This is because the reason for the soft agent is not powerful. This phenomenon is normal. Wait until the sticker softener is dry.The folds will be naturally flat.
Another phenomenon is that the stickers are wrinkled.That's because I did n’t post it, and it ’s okay if it’ s not long. Use my fingers to light some water to the position of the sticker, soak the stickers with water again.The model is not good, and the rest will be practiced by yourself.
